brazerzkidaiinsure.blogg.se - Hp agilent 82357b driver windows 7

#HP AGILENT 82357B DRIVER WINDOWS 7 INSTALL#
#HP AGILENT 82357B DRIVER WINDOWS 7 DRIVERS#
#HP AGILENT 82357B DRIVER WINDOWS 7 MANUAL#
#HP AGILENT 82357B DRIVER WINDOWS 7 SOFTWARE#

Selecting Log sweep will use logarithmically spaced frequency values for the sweep, and will change the display graph's X-axis to logarithmic mapping. This is useful for changing settings beyond those supported in software, e.g., bias level, zero calibrations, etc.įrequency sweeps can be specified using the sweep range sliders, or by entering values directly into the "start" and "stop" fields. The instrument can be operated using the front panel buttons by first pressing the "local" button.

Blue flashing: Read/write delay instrument I/O is occurring.

Each red flash indicates a new attempt to read measurements.

#HP AGILENT 82357B DRIVER WINDOWS 7 SOFTWARE#

A round indicator "LED" indicates the status of the software as follows:

Readings and error messages are shown in the lower left panel.

level, Display A type, Display B type, Circuit Mode, and Averaging control the instrument measurement settings. It may take several seconds to clear the interface of errors after updating the address. Enter the GPIB address for the instrument here. Instrument control settings are immediately sent to the instrument. When running, the software continuously triggers the 4192A instrument to perform measurements, unless "Pause reading" is selected.

If all else fails, exit the software, then restart the computer and the instrument.įinding the instrument and card index using NI MAX Performing measurements.

For example, 1:17 to specify card 1, address 17.

If multiple GPIB adapters are (or were recently) present, you might need to specify which card to use in the "Instr.

Use the Measurement and Automation Explorer software ("NI MAX", included with 488.2) to find or communicate with the instrument.

Ensure that NI 488.2 is properly installed and operational.

Ensure that the instrument is correctly connected and configured for GPIB communications.

The following troubleshooting steps are suggested if this occurs: Otherwise, the status indicator will flash red, and an error message will be displayed in the status area. Upon launching the software, if everything is configured correctly, measurements will begin immediately.

#HP AGILENT 82357B DRIVER WINDOWS 7 MANUAL#

The default address is 17 see manual section 3-117. Then connect the GPIB adapter, power on the impedance analyzer, and take note of the GPIB address displayed on the unit during start-up.

#HP AGILENT 82357B DRIVER WINDOWS 7 INSTALL#

Install LabVIEW RE and 488.2 software packages prior to using this software. Users will benefit from reading the HP 4192A product manual prior to using the instrument. This software was built and tested using the 2013 LabVIEW SP1 runtime engine, available here more recent versions should also work. This software was built and tested with NI 488.2 version 14.0 available here, other versions may also work.

#HP AGILENT 82357B DRIVER WINDOWS 7 DRIVERS#

Non-NI adapters may require additional software drivers or configuration steps. The Agilent 82357B adapter has also been used successfully. Known compatible GPIB adapters include those made by National Instruments such as the USB-GPIB-HS. Source code and binaries for other platforms are not available. This software is provided as a win32 binary, and should be capable of running on most PCs running Windows XP through Windows 10.

Low-frequency transmission line behavior.

This software provides remote operation, data acquisition, and data processing capabilities for the HP 4192A impedance analyzer. Help - HP 4192A Sweep Utility HP 4192A Sweep Utility Software Michael D.